butech fittings male-female-adapter-pneumatic-and-hydraulic

BuTech Fittings

Butech Fittings

BuTech fittings adapters and couplings are available to connect different sizes and pressure ratings of tubing and pipe. Standard construction is 316 cold – worked stainless steel. These couplings and adapters can be used with NPT pipe, single-ferrule compression tube, medium pressure cone and thread and high pressure cone and thread.

BuTech fittings are available in:

  • Male-Male Adapters
  • Male-Female Adapters
  • Female-Female Adapters
  • Elbows
  • Tees
  • Crosses
  • Bulkhead Fittings

BuTech fittings are also available for subsea and sour gas service.

GET A QUOTE
BuTech Valve Configurator
BuTech Valves Logo
butech fittings male-female-adapter-pneumatic-and-hydraulic

Can’t Find The Product You Need? Just Ask Us!

You May Also Like

Nitrogen Charging Cart

Nitrogen Charging Cart

Nitrogen Charging Cart

Haskel’s nitrogen charging cart is a mobile nitrogen solution that can be used in aviation ground support applications such as tire inflation, pressure gauge calibration, line flushing, charging landing gear struts and accumulators.  This nitrogen charging cart can also be used for the operation of pneumatic tools. The carts also enable operators to use all available gas in a bottle and still charge to final pressure.

Get A Quote
Haskel Pumps Logo
Nitrogen Charging Cart

Can’t Find The Product You Need? Just Ask Us!

You May Also Like

Bootstrap Nitrogen Boosters Bootstrap Pump

Bootstrap Nitrogen Boosters

Bootstrap Nitrogen Boosters

Bootstrap Nitrogen Boosters are simple area ratio piston type boosters that automatically reciprocate when gas pressure, up to 150 psi, is applied to the large low pressure drive piston. This piston is directly connected to small high pressure pistons inside the booting sections of both ends of the drive. Each boost section contains integral inlet and outlet check valves thereby producing a pumping action.

Unregulated Nitrogen or Helium from a supply cylinder(s) is directly connected at maximum pressure to the boost sections. Nitrogen to the drive section is regulated to 115- 120 psi by the integral drive control system Wearing parts are low cost elastomers and self lubricating engineering plastics, all available in seal kits, are field replaceable with simple instructions and conventional hand tools. Both units are lightweight, 1-man-portable, weather resistant and operate in any position.

These Bootstrap Pumps, also known as Bootstrap Booster Units, are designed for operators of helicopters and/or small aircraft where a portable self-powered booster is needed for ground support. The primary application is to service the high pressure on-board Nitrogen or Helium bottles on helicopters equipped with emergency inflatable “Pop Type” floats. However, using either model to service other components needing high pressure Nitrogen such as shock struts and precharging hydraulic accumulators is also common.

Get A Quote
Haskel Pumps Logo
Bootstrap Nitrogen Boosters Bootstrap Pump

Can’t Find The Product You Need? Just Ask Us!

You May Also Like

Haskel 1.5 Horsepower Air Driven Pump

Air Driven Pumps

Air Driven Pumps

Our huge air driven pump selection ranges from 1/3 horsepower up to 10 horsepower. Each air driven pump is available in multiple models, rations, pressure ranges and flows. Below you’ll find more information about each air driven pump range.

For help choosing the right Haskel pump for your application, give us a call at
877-836-1999 or use the Haskel Pump Selector.

Get A Quote
Download Brochure
Haskel Pumps Logo

Can’t Find The Product You Need? Just Ask Us!

You May Also Like